Installation Method Of Stone Cutting Machine

1, the first parallel placement of two of the track on the ground.

Its width is wide with the cutting rack walking wheel and so on.

2, in parallel orbit put on the rack, and the front and rear movement and the track is fully consistent and moving freely can be.

3, on the rack put on the cutting stone machine host, the host of the four rollers to be completely in line with the Groove steel on the rack, and the host after the movement direction and the movement direction of the rack is 90 degrees crossover and the respective movement freely.

4, the installation of power, so that the motor through the motor scaffold and the host firmly connected, and the direction of the motor axis and the direction of the host in the horizontal vertical crossover.

5, install the belt.

6, install the shield.

7. Start the motor, check the rotation direction of the saw blade shaft and the shield arrow indicates the direction of the same. 8, the installation of Saw blades.

Connect the water pipe. Stone cutting machine has the characteristics of high processing efficiency, low production cost, easy to use and so on, and has been widely used. In order to be able to play these functions properly, it is necessary to ensure the correct installation method, so, master the installation method of stone cutting machine, is the premise of normal work.

Time : 2020-05-14
LOCATION :Home - News - News